VIEW CART

Back to the EMF Harmonizers Page

How to Use and Install the Vortex Energizer

The Vortex Energizer, when attached to your home water supply pipe, energizes all the incoming water to your house—instantly and constantly. There are no further maintenance requirements.

Installing the Vortex Energizer in Your Home and Car

Before you fix the Vortex Energizer to your main water supply pipe, we recommend you first use it on all closed heating and cooling systems, such as the central heating, the fridge, and the freezer. Because these are all closed systems, you don't have to permanently fix the Vortex Energizer to them—as is necessary with the main water supply. Leaving the Vortex Energizer fixed to these closed systems for 24 hours is usually sufficient to transfer the energy permanently.

To energize your home central heating system, lay the Vortex Energizer on the floor with its apex pointing at and touching a pipe coming down from one of your radiators, for example, as shown. Leave the Vortex Energizer in this position for 24 hours, preferably with the heating on. This will ensure that the energy is transferred onto the whole system.

Following this, you may want to do the same with your refrigerator and freezer. (All food contains water and will benefit from being energized. This has shown to improve the taste and prolong the life of food and drinks.) Simply put the Vortex Energizer in the fridge for 24 hours to transfer the energy to food stored within the fridge and to the fridge's cooling system. The energized cooling system will then ensure that new food coming into the fridge will be energized even after the Vortex Energizer has been removed.

Do NOT put the Vortex Energizer in the freezer. Freezing the Vortex Energizer may cause its rivets, which seal the tube ends, to pop out. Just place the Vortex Energizer on or next to the freezer for 24 hours.

You can carry out the same procedure with your car's cooling system or even submerge the Vortex Energizer in your garden pond or swimming pool. An energized car cooling system transfers life force into the car's passenger section via the car's heater.

Installing the Vortex Energizer to Your Home Water Supply Line

We recommend you attach the Vortex Energizer permanently to your drinking water system. You need the Vortex Energizer permanently attached to ensure that all new incoming water becomes energized.

For maximum efficiency the Vortex Energizer should be attached to your house water supply line in such a way that the Energizer's apex is in direct contact with the pipe. A convenient and simple way is shown in the drawing to the right. The two straps provided are used to tie the apex and the top winding of the Vortex Energizer to the pipe. This method of attachment works equally well for vertical and horizontal pipes. If this method of attachment doesn't work in your situation, having the apex of the Vortex Energizer touching the pipe, as shown in the drawing above, will work equally well.

NOTE: In some homes or apartments, there may be more than one main water supply inlet and/or pipes may be less accessible. In this case the Vortex Energizer can be placed in a position near the individual spigots. In a bathroom for instance, water flowing into the sink, bath tub or shower takes on the energy from one centrally-suspended Vortex Energizer. However, if energized water is required in the kitchen as well as bathroom, another Vortex Energizer would have to be installed there as well.

Back to the EMF Harmonizers Page

Back Jack Chair  |  Nada Chairs  |  Benches & Zabutons  |  Yoga-Paws  |  Pin Hole Glasses  |  FREE Articles  |  On-Line Courses

Beeswax Candles  |  Evolutionary Music  |  Mind Expansion  |  EMF Harmonizers  |  Q-Link  |  Links/Resources

Home  |  FAQ's  |  Contact Us  |  Privacy Policy  |  About Us

Contact: Support@bodymindwisdom.com
© 2003-2008 Ofek Group Inc. All rights reserved.